LOCTITE PC 7202 is a two-part epoxy chocking system It is
recommended for the installation of main engines and other
equipment. Its high compressive strength withstands
maximum loads Typical applications include installation of main
engines, drive engines, winches, hoists, and deck mounted
equipment.

LOCTITE® SF 7070 is a non-aqueous, hydrocarbon based,
non-CFC solvent designed for cleaning and degreasing of
surfaces to be bonded with LOCTITE® adhesives. The product
is used as a final pre-assembly cleaning treatment to remove
most greases, oils, lubrication fluids, metal cuttings and fines
from surfaces to be bondedIt is designed to be used as a spray
or in immersion cleaning processes at room temperature or
heated.
Registered to NSF Category K1 for use as a cleaner and
degreaser in non-food processing areas which are used to
remove oil, wax, resinous materials, or other substances not
removable by using acidic or alkaline cleaning agents.

LOCTITE SF 7800 provides a corrosion protective coating
at room temperature on ferrous metals. Typical applications
include touching up metal parts after welding and to provide
long-term protection of metal assemblies. It is also used to
restore protection to repaired galvanized parts (e.g. crash
barriers, tubes, flanges, tanks, panels, etc.). This
product is typically used in applications with an operating range
of -50 °C to +550 °C.

LOCTITE® PC 7319™ is designed to protect equipment and
concrete against extreme corrosion caused by chemical
exposure, especially to sulfuric acid. LOCTITE® PC 7319™
forms a glossy, low friction surface under typical service
temperatures of -30 to 120 °C. Typical applications include
coating equipment to prevent corrosion, line tanks and
chutes, chemical containment areas, concrete pits, tanks,
floors and foundations.

Resimetal 101 Metal Repair Paste is a two component solvent free epoxy metal repair compound designed to fill surface erosion & corrosion on metallic surfaces.

LOCTITE PC 7202 is a two-part epoxy chocking system It is
recommended for the installation of main engines and other
equipment. Its high compressive strength withstands
maximum loads Typical applications include installation of main
engines, drive engines, winches, hoists, and deck mounted
equipment.

The Zinc Flakes form a resistant protective layer and has passed 550 hours salt spray test according to DIN EN 9227. It can be used for the coating of welded joints and drill holes as a conductive intermediate layer for spot welding and wherever metal must be protected against corrosion. It corresponds to ASTM A 780 as per repair coating for hot galvanized surface. Temp. Resistance upto 300'C